PMR release agent 3.8KG / bottle; 0.5KG / bottle, the product description: 1. Lee is a kind of mold to the mold surface such as Teflon to form a tough protective film of special additives, the effect of stripping can be formed. 2. Is a liquid form release agent, ease of processing, one coating can be repeated stripping. 3. Can reduce the residual mold phenomenon of SM, increased die life. 4. Has good heat resistance up to 4000 degrees, apply to any ERP product. 5. Not to transfer the products, easy-to facilitate the products after processing (such as painting, plating ....) Application and use Various new and old die die Before use, use solvent cleaning (eg acetone), be sure to surface clean of impurities and wax and to dry. 1. Will be dealing with mold with solvent (eg acetone) clean again to remove the surface impurities, particularly waxes impurities; 2. Die a clean dry cotton cloth with a spray or wipe coating manner PMR impose on the mold surface, so that its surface to form a wet film (do not flow without caking), each down 4-5 square; 3. Wait a moment after the flash film (at an ambient temperature of 70 degrees Fahrenheit for 15-20 seconds) with a clean cotton cloth to wipe the surface dry film surface and clean; 4. Repeat the process until the mold surface completely (PMR) coverage; 5. The proposed new mold coated with 4-5 layers, each time interval of 10 minutes; 6. After the last layer of coating to be placed after 20-30 minutes, and allowed to fully cure. Can be used in the production and obtained good release effect. Other Description: 1. Open the bottle cap after tightening will prevent moisture in the air to reduce product effect. 2. Please stay away from the air and power, to avoid prolonged skin contact. 3. Can wash with soap and water after use (this product is of low toxicity, low-active products, to avoid dipping into the eyes and other organs) Note: This product does not contain freon, no international environmental issues.

Wax Stripping Department of ejection by the Brazilian wax palm wax synthetic origin, quality and unique formula. Performance: 1. Yellow solid 2. Easy to use, with less, Tuomo easily 3. To provide high gloss surfaces Usage: 1. With a clean soft cloth (preferably cotton) to rotate the way the wax evenly on the mold surface; 2.15 minutes later, and then clean the surface of cotton will dim gradually rub paste to light; 3. Used in the old mold, just rubbed wax mold release once; if you need a new tool for use in repeated three times; 4. The last time to wipe the surface of the mold, after the amount of light, to put it aside for 1 hour or more before use, to achieve the best stripping results.